Endless Wishes Christmas Card-Tutorial

Endless Wishes Christmas card-Tutorial

Materials Required (as seen in top 2 pics below):

Endless Wishes Stamp set

Glass blocks (to place photo polymer stamp on)

Pear Pizzaz Ink

Costal Cabana Ink

Whisper White card stock

silver Glimmer paper

Costal cabana card stock (optional)

labels punch or die

if you use a die you need a Big shot die cutter/embosser

sponge

adhesive snail (rolling double sided tape)

dimensionals

Paper trimmer

Step one

Cut your top sheet to 4" x 5 1/4" in Whisper White card stock

Step 2

mount the snow flakes onto the blocks (peel and stick)

tap the stamp a couple times onto the ink pad them press directly down and firmly onto your paper following the design or place where ever you like.  I used the Large and small snowflakes in the pear pizazz ink and the medium snowflake in the coastal cabana

Step 3

cut out your pop up label using your die and big shot in whisper white 

alternatively you could use a labels punch or

you could use a simple circle or square

Step 4 

Using your medium sized snow flake and still the coastal cabana ink "stamp off" once then directly onto your label to make to make a lighter impression.

Step 5

Arrange your greeting onto the glass block-there are several to choose from in the set, i suggest you practice to see the alignment.  Then stamp the greeting onto the label.

Step 6 

using the piece of sponge, dip it onto the costal cabana ink and then brush all the edges of the label and the card piece you have stamped all ready.

Step 7

cut costal cabana card stock 1" x 4"

cut silver glimmer paper 3/4" x 4"

using your snail (double sided adhesive tape) run a line on the back of the silver and place centred onto the costal cabana

if you wanted to skip either of the bands a single band would suffice

Step 8

Run the snail in a strip on the back of costal cabana strip then mount onto to card front

Step 9

Place 2 Dimensionals onto the backside of the label then mount onto the strip

Step 10

cut Whisper White card stock in half to make a 5 1/2" x 81/2", then fold in half to make a side opening card sized 5 1/2" x 4 1/4 "

Step 11

Run the snail on the backside of the card front top and bottom, centre it onto the card base and affix .

If you wish to you can add a greeting on the inside or you can leave it blank.

And you are DONE!

you can purchase all the supplies needed at:

www.sandibellinger.stampinup.net